This version (14 Jan 2021 05:34) was approved by Robin Getz.The Previously approved version (22 Aug 2019 10:05) is available.
Table of Contents
ADRV9371/PCBZ Quick Start Guides
The Quick Start Guides provide a simple step by step instruction on how to do an initial system setup for the ADRV9371-N/PCBZ, ADRV9371-W/PCBZ boards on various FPGA development boards. They will discuss how to program the bitstream, run a no-OS program or boot a Linux distribution.
Supported Carriers
The ADRV9371/PCBZ is, by definition a “FPGA mezzanine card” (FMC), that means it needs a carrier to plug into. The carriers we support are:
| Board | ADRV9371-N/PCBZ | ADRV9371-W/PCBZ | ADRV9375-N/PCBZ |
|---|---|---|---|
| ZCU102 | √ | √ | √ |
| KCU105 | √ | √ | √ |
| ZC706 | √ | √ | √ |
| Arria 10 SoC | √ | √ | √ |
| Arria 10 GX | √ | √ | √ |
Supported Environments
The supported OS are:
| Board | HDL | Linux Software | No-OS Software |
|---|---|---|---|
| ZCU102 | √ | √ | √ |
| KCU105 | √ | √ | √ |
| ZC706 | √ | √ | √ |
| Arria 10 SoC | √ | √ | |
| Arria 10 GX | √ | √ | √ |
Hardware Setup
In most carriers, the ADRV9371/PCBZ board connects to the HPC connector (unless otherwise noted). The carrier setup requires power, UART (115200), ethernet (Linux), HDMI (if available) and/or JTAG (no-OS) connections. A few typical setups are shown below.
ZC706 + ADRV9371/PCBZ
ZCU102 + ADRV9371/PCBZ
Connect ADRV9371 into HPC0 on your ZCU102.
Unboxing guide
resources/eval/user-guides/mykonos/quickstart.txt · Last modified: 14 Jan 2021 05:24 by Robin Getz